[joshuac]

Hello people.

First i want to say, this forum is very very good, speciall thanks to all.

I have an machine with a Fanuc i series control (see attach pictures)

My problem is: i can't do DNC mode.

I can transfer small files to memory of machine with rs232 cable, but i can't do DNC for big files...

it's possible, if someone know, how to do??

regards.
joshuac

[frigoteknika]

hello

we hawe the same problem with murata wiedemann turret punch,ween we make big programs we devide these in .PAT

HAWE NICE DAY

[joshuac]

hello

i think it's possible we active DNC function, i don't know how... I try to change some system values but without results

regards
joshuac

[dcoupar]

If you select TAPE mode, does RMT display at the bottom of the screen? If so, try turning on SINGLE BLOCk switch and press CYCLE START. Does LSK flash at bottom of screen? If so, send the program from PC to the CNC. You should see the program displayed on the screen.

[joshuac]

If you select TAPE mode, does RMT display at the bottom of the screen? If so, try turning on SINGLE BLOCk switch and press CYCLE START. Does LSK flash at bottom of screen? If so, send the program from PC to the CNC. You should see the program displayed on the screen.

Yes it works.

thanks @dcoupard i don't know what is TAPE mode...

Now i can do big programs :rainfro:

regards
joshuac