[Antonio Arguijo]

Hello! I have a problem in a John Ford Machine lathe, FANUC control O-T, with the order position tools in the turret, someone knows how adjust it?:rainfro:

[guhl]

do you mean the real tool doesn't match the tool # in program?
if so, find counter, corresponding to tool positions and enter the valid number
counter you can find in ladder

[Antonio Arguijo]

eFECTIVELY, BUT HOW CHANGE THIS COUNTER IN THIS CONTROL?

[chich2]

Antonio,
There is a cnczone member here called "fanuc-support.c"
Try sending a PM with a link to your thread so they can reply to it.

Chich

[stevo1]

eFECTIVELY, BUT HOW CHANGE THIS COUNTER IN THIS CONTROL?

IIRC you have to set PWE bit to 1 then go into your counters and locate the proper one you need to change. Once highlighted you have to be in MDI mode to change it.

Stevo

[fanucman]

IIRC you have to set PWE bit to 1 then go into your counters and locate the proper one you need to change. Once highlighted you have to be in MDI mode to change it.

Stevo

zeros dont have counters page.. its in the diagnostics

call johnford they will tell you

[stevo1]

zeros dont have counters page.. its in the diagnostics

call johnford they will tell you

You are correct. Thank you for clarifying.

Stevo

[tano]

Do you fix the problem ?