[laserh20]

My vmc 760/22 has been running great until one of my guys e stopped the machine during a tool change. Now, no matter what I do, I get a message that the tools need to be reloaded.

In addition, when I try to do a tool change, immediately after the z axis jogs up it moves down very fast and gives me an error: "following error limit exceeded" I also get this error if I do a quill up.

I have tried about everything I can think of to solve this problem.

the machine homes and jogs. the carousel for the tool holder homes fine.

Please help.

[machintek]

You did not state what control.

George

[shootrr]

Its been years since i was on a brideport its a dx-32 controller right? the machine is confused as to which tool is in the carousel and which tool is in the spindle, as I dont have access to any manuals i am searching my notes but most likely i purged the info. When the e stop was hit the spindle didnt hit anything before it stopped did it? the 760 and torq-cut will sometimes loose z position if the spindle hits something this needs to be reset if it did. Sorry i wasnt any help yet but i will keep looking for how to reset tool numbers in the carousel.

[laserh20]

yes it is a dx32 control

[shootrr]

i have looked for information i might have had but no luck, i purged anything i had in notes when we got rid of our 760 sorry,

[Shreesh]

Dear Sir,
do you have electical circuit diagram for Brigeport 760/22 and alarm code manual for it. I have got hedinian control 370 tc installed in it and drive is of sinodrive 611 make siemens.

Regards,
Shreesh