I run a Victor CNC TNS-3H Lathe with Fanuc 10T. Normally it works just fine, but now when i do a toolchange in a program or MDI, both X and Z start to move at the same time the turret indexes. It moves in rapid and if i don't stop/reset, it would run into the chuck.
The work zero and tool offsets are ok...
Any ideas what the problem could be?
Results 1 to 3 of 3
-
06-04-2010, 08:48 AM #1
Registered
- Join Date
- Jun 2010
- Posts
- 0
Toolchanger problem with Fanuc 10T
-
06-04-2010, 03:33 PM #2
Gold Member
- Join Date
- Mar 2003
- Posts
- 2932
Is it possible that someone changed parameters?
#6001 bit 2 = 0 applies the geometry offset by shifting the work coordinate system.
#6001 bit 2 = 1 applies the geometry offset by moving the tool.
bit 3 is the same for the tool wear offset.
-
06-07-2010, 06:39 AM #3
Registered
- Join Date
- Jun 2010
- Posts
- 0
No, it's only me using the machine. I restarted the machine a few times and after a few hours it was working again, i guess its just old :P
I'll check that bit if it happens again! Thanx
Reply With QuoteSimilar Threads
-
toolchanger on MB3 VMC
By underdog in forum HURCOReplies: 4Last Post: 03-21-2009, 10:42 PM -
diy toolchanger???
By marcerasmus in forum Metalworking- / Woodworking Tooling / Manual MachiningReplies: 2Last Post: 10-08-2007, 05:24 AM -
cnc DIY toolchanger???
By marcerasmus in forum CNC ToolingReplies: 1Last Post: 10-07-2007, 10:30 PM -
Fanuc 0i-MC and ARM type toolchanger
By ddanutz in forum FanucReplies: 4Last Post: 08-27-2007, 10:57 PM
Posting Permissions
