Guys,
My OKK PCH 500-II has ATC problem after replace the new Fanuc controller, not sure it relate to parameter or not.
The ATC just not response and I can not operate the magazine in any mode and the machine doesn't has any faults
Guys,
My OKK PCH 500-II has ATC problem after replace the new Fanuc controller, not sure it relate to parameter or not.
The ATC just not response and I can not operate the magazine in any mode and the machine doesn't has any faults
There is a servo amp for the mag. motor in the control cabinet by the main power switch. check the parameters in it.