Hello and thanks in advance. Just took possession of two, Mori SH-403’s. Both have the MSG-501 control. We also have five, Partner M300s. On the M300s M6 will send spindle to tool change position. On other builders I have created a macro to do this as it ads on loading tools thru the spindle, and then assigned it to an M code. Does anyone know if there is something that can “be changed or turned on” to have M6 send the spindle to tool change on the SH's?
Also, the control says I have 130,000 bytes of free space, but I cannot load a core roughing program of 110,000 bytes. On our NL’s, I have used DNC Tape mode to run a large program off the memory card. I did try the same thing on the SH but no luck. Does anyone have any ideas that may help. Once again, thank you very much.