[MARCINZUR]

Hi
I deleted all parameters.
My machine: Leadwell MCV-0 FANUC OM
Please help!!

[fanucman]

do you have another one (machine)?

did you check for a list in the back of the machine?

did you call leadwell yet?

[Al_The_Man]

You also need the 900 option parameters, the diagnostic/counter/timers and any 9000 macro programs.
Al.

[aadilsakhawat]

hi,i have a Option Parameters, NC Parameters & Pc Parameters fanuc OM-A MCV-OP leadwell machining centre you need fanuc OM-A.plese send e-mail ([email protected]

[vivek patel]

Hi we have all parameter of that machine if you required then plz mail me at [email protected]

Another thing if i want to run the machine in dnc mode then,have any bit or M code for the same?
And also we have not manual of that machine can you provide manual?

[MachII]

We have a 1995 Leadwell MCV-OP L2SIE0323, Fanuc OM. We're replacing the memory board and need the parameters for this. Do you have parameters for this model?

[Manenitin200]

[QUOTE=MARCINZUR;790755]Hi
I deleted all parameters.
My machine: Leadwell MCV-0 FANUC OM
Please help!


Pls send me parameters Leedwell MCV O FANUC OM
[email protected]

[danby]

We have a 1995 Leadwell MCV-OP L2SIE0323, Fanuc OM. We're replacing the memory board and need the parameters for this. Do you have parameters for this model?

You have The OE1 AND OE2 eprom files în hex format?.I change The controller for my MCV with 0MF and i need change The memory on Mainboard.
Pls sens an email [email protected]

[McStu]

Did anyone get the parameters for this? I need them for leadwell mcv 1000bp with fanuc omf control, I have everything working except the tool change, can do most tool change movements in mdi via g and m code but program just stops after g28 z0, maybe a diognostic or timer parameter, in manual mode I get a 1046 then 530 alarm when trying to get to g30 2nd z 0. Thanks

[zoubin]

Hartford VMC-1020
SYSTEM:0M
PMC OE1/2 CHIP LOST
I have a Hartford VMC-1020 with Fanuc O-MD system, but the PMC ladder diagram is lost.
Could you please send me an OE1/OE2 file OR Picture? Thank you very much!
Email:
[email protected]