So I am currently trying to find ~1" - > 1.25" OD pulleys for 1/16" cable/string. I need around 10 of them and would prefer if they would have mounted bearings or if nothing else solid instead of sintered metal.

I have been using some cheap ones from HF but they are riding on very bad shafts and end up contributing way to much friction to the system where the rough sintered side rubs against the blocks body.

Ideally I need a few that are surface mount and a few two pulley blocks. I can't find anything in this size range up to this point.

The load ratings is a bit up in the air depending on what i'm able to find. I should be able to adapt the design to suit what I find.

Open to any suggestions.

Of course i don't have a desktop lathe or this would be done by now!
Maybe this would be a reason to finally get one.