[segal.arye]

WGH

Sup, guys?

I've posted a thread yesterday in the "General Metalworking Machines" forum, but didn't get an answer so far, so I thought I'd refer you guys to it, since it seem more relevant to this forum and to Tormachs'.

Here is the link to the thread: http://cnczone.com/forums/showthread.php?p=796185 .

If you guys would be kind enough as to read and reply to it, I'd appreciate it a lot!

Thanks a ton you guys and sorry for double posting,

Arye Segal.

P.S.: I've also posted the exact same message on the "Tormach PCNC" forum.

[sharpshooter90]

WGH

Sup, guys?

I've posted a thread yesterday in the "General Metalworking Machines" forum, but didn't get an answer so far, so I thought I'd refer you guys to it, since it seem more relevant to this forum and to Tormachs'.

Here is the link to the thread: http://cnczone.com/forums/showthread.php?p=796185 .

If you guys would be kind enough as to read and reply to it, I'd appreciate it a lot!

Thanks a ton you guys and sorry for double posting,

Arye Segal.

P.S.: I've also posted the exact same message on the "Tormach PCNC" forum.

This forum is very inactive, which probably says a lot about the products. See my answer over on the Tormach forum.

[g29cc]

I don't see too much activity here. Which is something to look at then. Because if the end users aren't active, than I hate to say that it usually means there aren't that many users out there compared to the more active forums. That doesn't mean its a bad product, but just not a common used one.