586,043 active members*
3,595 visitors online*
Register for free
Login

Thread: Locked out!

Results 1 to 2 of 2
  1. 07-10-2010, 02:32 AM #1
    M99 Dan
    M99 Dan is offline Registered
    Join Date
    Feb 2010
    Posts
    0

    Locked out!

    I turned on My V2XT this morning and I got a black screen with "Enter current password" I have never seen this before and I have no idea what to do. I get three tries and then I get a locked out. Help!

    It is a 1997 DX32 control. I have no boot disk.

    Dan
    Reply With Quote Reply With Quote
  2. 07-10-2010, 03:13 AM #2
    machintek
    machintek is offline Moderator
    Join Date
    Nov 2004
    Posts
    3028
    What I believe happened is that the CMOS got screwed up. That is the only place that you could be confronted with a password.
    to clear it you need the book on the mother board showing the jumper to clear the MOS and with it the password.

    George
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Stepper motor locked up
    By jeffmorris in forum DIY CNC Router Table Machines
    Replies: 5
    Last Post: 08-26-2013, 10:45 AM
  2. ladder locked out BP 412 Fanun 0-MF
    By eng101 in forum Bridgeport / Hardinge Mills
    Replies: 18
    Last Post: 03-26-2012, 10:40 PM
  3. locked out of my fadal
    By sec1964 in forum Fadal
    Replies: 2
    Last Post: 03-23-2009, 09:19 PM
  4. locked programs
    By stevo1 in forum Fanuc
    Replies: 0
    Last Post: 07-09-2008, 05:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules