[LouF]

Jerry, I upgraded my Aspire and I think it messed up some stuff. I haven't dug into it yet, but I think the post processor was overwritten.
Machine Always does an initial tool change, even when to correct tool number is in during start. In other words, Tool 1 is installed, the Tool Number is #1 in Mach. I zero the tool on the plate, then it goes to the fixed plate, then wants a tool change, then does the fixed plate again, then it starts cutting. Also, No more parking when complete, goes to tool change position.

A few other small oddities. Honestly it was a while back when I set all this up and it's been going great until recently.
Any pointers so I don't spend lots of time troubleshooting?

Richard

My machine is doing the same when I click for one tool it goes to the removable plate then I click it again to start cutting it goes to the fixed plate as well.