586,308 active members*
3,563 visitors online*
Register for free
Login

Thread: Leveling GT-10

Results 1 to 3 of 3
  1. 07-12-2010, 04:38 PM #1
    Vern Smith
    Vern Smith is offline Registered
    Join Date
    Dec 2006
    Posts
    447

    Leveling GT-10

    I would like to check the leveling on my GT-10. I planned on checking the Z by putting a ground bar in a collet unless there is a better way. The X I'm not so sure about. There is a machined surface that the turret bolts to. I would think this is parallel to the X ways and would be a good spot to check for level in the X axis?

    Vern
    Reply With Quote Reply With Quote
  2. 07-30-2010, 02:01 PM #2
    Geof
    Geof is offline Gold Member
    Join Date
    Jul 2005
    Posts
    12177
    I was away and didn't see this thread until now. We use the machined surface you mention on our GT20s and I am confident it is adequate. These machines are so small setting them perfectly level is not really necessary. Just make sure all the levelling screws are carrying the same load.
    An open mind is a virtue...so long as all the common sense has not leaked out.
    Reply With Quote Reply With Quote
  3. 08-24-2010, 11:12 PM #3
    Vern Smith
    Vern Smith is offline Registered
    Join Date
    Dec 2006
    Posts
    447
    Geof,

    I used the machined surface and she was close enough for government work. Thanks for the help.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. leveling cnc lathes
    By cordeirot in forum Community Club House
    Replies: 2
    Last Post: 04-17-2010, 01:35 AM
  2. Leveling an X3
    By pntrbl in forum Benchtop Machines
    Replies: 5
    Last Post: 01-10-2010, 08:17 PM
  3. Leveling qt15!!!!!!
    By carbidecraters in forum Mazak, Mitsubishi, Mazatrol
    Replies: 2
    Last Post: 03-10-2009, 11:34 PM
  4. leveling???
    By samu in forum Uncategorised MetalWorking Machines
    Replies: 3
    Last Post: 05-12-2008, 01:51 AM
  5. leveling
    By samu in forum Bridgeport / Hardinge Mills
    Replies: 1
    Last Post: 05-01-2008, 04:43 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules