One side of ATC arm is a little deformed due to crash. It's possible to use ATC arm single side in two ways:
1. correct programs so, that before each tool change goes spindel empty (M63 M6)
2. parameter set.
The question is which parameter is responsible for that? OSP U100M
Results 1 to 1 of 1
-
08-04-2010, 10:04 AM #1
Member
- Join Date
- Mar 2009
- Posts
- 1982
MX-46VAE ATC arm single side mode
Reply With QuoteSimilar Threads
-
What is - Torque Mode? Position Mode? Speed/Velocity Mode?
By sunmix in forum Servo Motors / DrivesReplies: 48Last Post: 01-20-2024, 10:34 AM -
Auto mode only after single block
By fomaz in forum FanucReplies: 7Last Post: 04-17-2010, 10:53 AM -
Single Side driven Router?
By keyne in forum DIY CNC Router Table MachinesReplies: 10Last Post: 03-26-2006, 04:31 PM -
linear slides X-axis single side or dual?
By PlasmaGuy in forum Linear and Rotary MotionReplies: 2Last Post: 02-16-2006, 06:44 AM -
Single line mode works well, Auto is not soo good??
By Darc in forum CamSoft ProductsReplies: 16Last Post: 10-26-2004, 09:29 PM
Posting Permissions
