its not easy being green
its not easy being green
I made a longer mounting plate that will let me lower the spindle an additional 3 1/2" if necessary. Attached is a sketch showing the hole locations for mounting a Tekno spindle. Also a pic showing the spindle mounted to the new plate.
Tramming the spindle is a 2 part process. First, you must make sure the Z axis itself travels perpendicular to the table top. Next, you have to make sure the spindle is square to the table. If anyone is interested, I'll take a few pictures to explain the process. FYI, you don't need any expensive tramming tools. A solid square, an indicator & an bent piece of 1/4" rod are all you need.
edit: sorry for poor sketch. blame the forum for rendering it like that.
That plate looks interesting. I'm a woodworker not a machinist, so I'm not sure if I could get your results. That said, flex has been raised as a concern with extensions. What's been your experience with the plate? What thickness and type of aluminum did you use?
Thanks. John
I made my own version of the raptor machine taking many concepts direct from George. Here is what I did on my z axis. I have just over 10" of travel.Attachment 286416
I made my own version of the raptor machine taking many concepts direct from George. Here is what I did on my z axis. I have just over 10" of travel.Attachment 286416
Hmmm. Clearly you are on a different plane regarding CNC machines and machining. I'm looking for an enhancement to a stock Raptor machine. At this point I'm still hoping George can find a cost effective solution.
Good tip on an easy tram tool. Thanks!
John
Hey George, do you have any dust boots for the teknomotors anf what do they cost? I didn't see it on your website
What size hole or hose connection is it? Also what is the distance from where it mounts on the teknomotor to the outside face that holds the brushes? I may not have the same clearance as you do behind the spindle.
Should have been an attached photo
OT, New day, new question.
I just purchased a dial indicator, the fellow added in a box of maxi-kut fly cutters with 1/2 inch shafts, look to be Weldon shanks. I'm thinking these cannot be used in a Hitachi router and probably not on a drill press either. Before I put them up on kijiji, I thought I would check here to see what machines can take them.
Thanks
John
1/2" shank is fine in the router. weldon flats are for set screw holders, but they dont prevent the tool from being used in a collet. its a flyfutter, so you wont be spinning them fast - as slow as possible actually, so balance shouldnt matter.
That's a pleasant surprise!
What's a maximum safe speed? I ask because I have a superPID kit, which I have not installed. Base RPM for the Hitachi is around 8,000 RPM, and I have a hard time picturing this gear spinning that fast.
Appreciate the help.
John
fly cutters typically dont run more than 1000rpm. but thats limited by the cutting parameters of metal.
search online for the company that manufactures the fly cutters and they may suggest a limit. 8krm if they are set to a small diametre might be usable.
Changes to a few machines.
Now fly cut backing on backing plate for flatness .
Inside of uprights for mounting of ballscrew end .
Attachment 287090
Attachment 287092
Attachment 287094
XZero cnc
Have now IKO , SBC blocks and rails as option now.
SBC black rails and blocks. Stay rust free
IKO maintenance-free 5 year 20.000KM warranty at maximum capacity , on router lucky if it is 20 % of capacity
Here is New IKO blocks
Attachment 287098
XZero cnc