[beekeeper]

I was setting an offset and hit the soft limit on z- travel I raised the machine up and it would not reset the alarm I have tried to reference machine but wont do it with the alarm. I can raise in the z plus direction I have tried powering the machine down twice but it will not reset the 231 alarm z ot I am guesing this is in the servo is there any help in getting this reset thanks

[dcoupar]

"231: A movable part of the machine tool touched the Z axis minus stroke limit switch."

Sounds like maybe the overtravel switch is sticking. See if you can find the switch and manually actuate it to free it up.

[dung_ninhbinh]

Hi beekeeper,
you push the Cancel limit button and reset, after remove your Z axis up. Or you can see a switch limit button under Z axis bottom.

Do you want i go to to work for you?