586,047 active members*
3,693 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > Spindle Drive fault 60, A06B-6111-H015

Thread: Spindle Drive fault 60, A06B-6111-H015

Results 1 to 2 of 2
  1. 11-22-2010, 07:36 PM #1
    FanucIssues
    FanucIssues is offline Registered
    Join Date
    May 2007
    Posts
    58

    Spindle Drive fault 60, A06B-6111-H015

    Spindle Drive fault 60, A06B-6111-H015#H550. I have an issue with a Doosan lathe, it has a Fanuc OI controller, the Message is:

    9110 SPN 1:S-Spindle error (AL-110)

    And the Spindle drive has the 60 alarm, the power supple is showing an "A" state...I am not familiar with this fanuc controller, and our books only show error codes up to 59. I have not seen the 9110 anywhere in the Doosan books, but I am assuming a 9000 series alarm has something to do with the controller....

    Any thoughts to help me out?
    It's not what you cut...It's what you don't cut.
    Reply With Quote Reply With Quote
  2. 11-22-2010, 09:43 PM #2
    bmngator
    bmngator is offline Registered
    Join Date
    Jul 2008
    Posts
    29
    9110 is a communications error between the amp and the module.
    I believe the spindle amp is showing b0 not 60. Check your cables or it could
    be your spindle amp.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 1992 VF2 Alarm 123 spindle Spindle Drive Fault
    By dafowfidy in forum Haas Mills
    Replies: 15
    Last Post: 05-14-2012, 07:32 PM
  2. Spindle Drive Fault
    By bk1955 in forum Bridgeport / Hardinge Mills
    Replies: 3
    Last Post: 10-19-2010, 02:24 PM
  3. FANUC OT B Spindle rpm fluctuating and causing 1008 Spindle Drive Fault
    By Bill Gillen in forum Fanuc
    Replies: 4
    Last Post: 10-15-2010, 07:10 PM
  4. Fanuc A06B 6064 C312 Spindle drive
    By jkford96 in forum Fanuc
    Replies: 5
    Last Post: 02-21-2007, 04:16 AM
  5. Spindle Drive Fault
    By n5jjr in forum DNC Problems and Solutions
    Replies: 15
    Last Post: 03-31-2005, 03:26 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules