I once used this thing that holds a collet, from a hardinge lathe, in a block. The block could then be mounted in a vise. This was a nice way to hold round parts in the vise, but I don't know what this is called or where to buy one!
For precise work, a collet holder in the vise is a good method, I think. But for larger pieces this isn't possible (with my collets). A less repeatable way would be to have a 3-jaw chuck that sits in a vise, or is mounted directly to the table. I'd really like one of these, but again, I'm not sure how to go about finding it.
Any advice/experience is greatly appreciated,
Thanks,
Matt