Originally Posted by
el_gotico
2 years later, Similar problem. Different Machine: 2 Yrs ago i gave up on the B8001 and got an AKD-B00606-NBAN-0000. the motor on this machine is AKM42G-EKCN2-00. Using Workbench configuring and getting the machine running was a piece of cake. Now, on a similar machine, i got rid of the B8001 wihout wasting time and got an AKD Drive. Problem? the motor is IDC G34VI-b32-0100-v. Wired everything and got a motor file for a B32 motor from Kollmorgen. Problem now it will enable ok, as soon as i touch the shaft it faults out on foldback. the motor goes to 10 amps. I put the old B8001 and it runs for 2-4 hours then it faults out on step mismatch (reason i'm trying to get rid of it). Any ideas are appreciated. So Far i've tried swaping S and T on the halls, swapping Enc A for B and B for A. Checked all my wiring about 10 times. I havent tried to swap the new AKD with the other that has been running for the past 2 years. I apologize in advance if this post is off-topic on this thread. Any help is appreciated.