Hello:
I am new to this site but I'm thankful it's here! I hope to gain a lot of knowledge here and hope to help out whenever i can. My question is: I'm working on a Mitsubishi 2512HD with a LC10 controller. I'm having to reprogram the LC10 because the machine was brought back up after having been off for a few months. The LC10 sees the x axis but not the y and z axis. The people at Mitsubishi tell me its in the system parameters but I cannot find it. Can anyone help me with this? Any other advice about bringing this kind of laser back up from the dead would be very appreciated. Thanks!