[hrhoward]

Hello.

We just got a very nice looking Mori Seiki SL-25B5 with a Fanuc O-T control.
I have an Alarm 100 p/s.
I can zero out the X and Z and jog them around.
I have absolutely no documentation on this machine (serial number 3432).
How do I figure out what memory has been lost? (out of service for several years)
I might have a Fanuc O-T manual.

Any help would be appreciated.

Thanks,
Heath

[Al_The_Man]

Alarm 100 is usually when the PWE 'Parameter Write Enable' bit is set, this can be confirmed on the 'Setting' screen.
This will usually put the machine into E-Stop!.
Do you have the parameters on the machine?
900 Options, user par. and diagnostic counter/timers in either hard or soft copy?
Al.

[underthetire]

It won't estop a Mori. You can even hit cancel and reset at the same time and the alarm will clear, allowing full operation of the machine.

[hrhoward]

Thanks for the replies fellas.

Al, I have no documentation on this lathe.

underthetire, I will give that a shot tomorrow morning.

Heath

[underthetire]

You still will need to eventually turn off PWE in the settings page.

[Al_The_Man]

If you P.M. me an email add I can help with the manual.
Al.

[hrhoward]

Will do Al.

I cleared the alarm. I can get the spindle and axis' to jog now.
Thanks!

I have a turret alarm now but I will start a new thread on that one.

[Al_The_Man]

If you have the right 0T version you should be able to trouble shoot that with the on screen ladder display.
It is turned on by a user parameter if it is displayable.
P0060 bit #2.
Al.

[underthetire]

Mori usually has a displayable ladder. Sometimes it asks for a password, type in "L" then hit input. Post the alarm and i can help.