hi all... i have a fadal vmc3020 with siemens sinumerik 810d.
my problem is... yesterday, the machine was working fine and suddenly stopped... now it doesn't work... in manual i can start the spindle in ccw with no problem but in cw it stops... maybe is a spindle drive problem?? is there a way to repair it without sending the drive to siemens (too expensive) ????
hope you can help me
Thread: hi all... need some help
Results 1 to 6 of 6
-
10-23-2010, 02:24 PM #1
Registered
- Join Date
- May 2006
- Posts
- 6
hi all... need some help
-
10-23-2010, 09:15 PM #2
Registered
- Join Date
- Aug 2006
- Posts
- 98
When you turn in CW mode, what alarm´s appears ???
-
10-24-2010, 08:52 PM #3
Registered
- Join Date
- May 2006
- Posts
- 6
when i turn cw it appears.... 20215 c1 axys fault.
i'm not sure of the number... i'm not the operator of the machine. my brother is but i think tha's the message.
-
10-24-2010, 09:30 PM #4
Registered
- Join Date
- Aug 2006
- Posts
- 98
Turn in CW direction and press the MESSAGE key to confirm the exact alarm number
-
10-25-2010, 08:55 AM #5
Registered
- Join Date
- May 2006
- Posts
- 6
i get two alarm messages... 25201 and 21612
-
10-26-2010, 12:10 AM #6
Registered
- Join Date
- Aug 2006
- Posts
- 98
Please, check this signal in PLC screen : (DB31 - 48, DBX 2.1). This signal is the enable/disable drive.
Reply With Quote
Posting Permissions
