[Rally]

I have set up a post for a Hurco and need help with the stucture of the Drill can cycles. If anyone coujd help that would be great. VM5 by the way!
The format I have now (Standard Drill) is as follows.
[SEQ_PRECHAR][SEQNUM] G00 X[NEXT_NONMDL_X] Y[NEXT_NONMDL_Y]
[SEQ_PRECHAR][SEQNUM] Z[CYCL_CLEAR]
[SEQ_PRECHAR][SEQNUM] [G_CODE] X[NEXT_NONMDL_X] Y[NEXT_NONMDL_Y] Z[CYCL_CLEAR+DEPTH] F[CYCL_IPM]

that however does not post in the proper format. Here is the output I need.

N1 G90
N2 T1 M06
N3 Z2.000 S1200 M03
N4 G00 X2.888 Y0.827
N5 M08
N6 Z2.0
N7 Z0.1
N8 G81 X1.000 Y1.000 Z.6 F1.0
N9 G80 Z2.000
N10 M09

Thanks for any help

[Rally]

Found the answer to my question! I figured I'll go ahead and and post this just in case someone else needs this.

Here is the Stucture for Standard!
[SEQ_PRECHAR][SEQNUM]G00X[NEXT_NONMDL_X]Y[NEXT_NONMDL_Y]
[SEQ_PRECHAR][SEQNUM]Z[CYCL_CLEAR]
[SEQ_PRECHAR][SEQNUM][G_CODE]X[NEXT_NONMDL_X]Y[NEXT_NONMDL_Y]Z[CYCL_CLEAR+DEPTH]R[CYCL_CLEAR]F[CYCL_IPM]

Here is the one for deep drill!
[SEQ_PRECHAR][SEQNUM][OUTPUT_UNITS_CODE][SPINDLE_BLK]
[SEQ_PRECHAR][SEQNUM][RAPID]Z[CYCL_Z+CLEAR]
[SEQ_PRECHAR][SEQNUM][G_CODE]X[NEXT_NONMDL_X]Y[NEXT_NONMDL_Y]Z[CYCL_CLEAR+DEPTH]Z[CYCL_INCR]Z[CYCL_INCR]R[CYCL_CLEAR]F[CYCL_IPM]

Hope this helps someone else