586,105 active members*
3,111 visitors online*
Register for free
Login

Thread: RFQ on turned steel parts

Results 1 to 4 of 4
  1. 11-10-2010, 08:20 PM #1
    TheGreenMachine
    TheGreenMachine is offline Registered
    Join Date
    Nov 2006
    Posts
    48

    RFQ on turned steel parts

    I am looking for a quote on 200 of these, please include a turn around time. I just noticed that the drawing dosen't show a chamfer on the parted end. I usually put a .010" chamfer with the parting tool and would like that done, the parting nub can also be as large as .035".
    Attached Files Attached Files
    Reply With Quote Reply With Quote
  2. 11-11-2010, 06:39 AM #2
    Dualkit
    Dualkit is offline Registered
    Join Date
    Jan 2008
    Posts
    449
    Your PM box is full and I don't open quote, either clear the box, post an e-mail address or e-mail me at [email protected]
    Reply With Quote Reply With Quote
  3. 11-11-2010, 06:42 AM #3
    TheGreenMachine
    TheGreenMachine is offline Registered
    Join Date
    Nov 2006
    Posts
    48
    Inbox cleared
    Reply With Quote Reply With Quote
  4. 11-12-2010, 07:15 PM #4
    TheGreenMachine
    TheGreenMachine is offline Registered
    Join Date
    Nov 2006
    Posts
    48
    The job has been awarded, thanks to those that submited a quote.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Turned parts on a mill
    By cncwhiz in forum Uncategorised MetalWorking Machines
    Replies: 16
    Last Post: 08-30-2009, 04:34 AM
  2. RFQ - Two Small Turned Aluminum Parts
    By AuroraDrvr in forum Employment Opportunity
    Replies: 6
    Last Post: 04-18-2009, 08:02 PM
  3. RFQ - Turned Steel w/ Drilled & Tapped Set Screws (Cancelled)
    By AuroraDrvr in forum Employment Opportunity
    Replies: 5
    Last Post: 04-14-2009, 07:12 AM
  4. RFQ - turned parts
    By Runner4404spd in forum Employment Opportunity
    Replies: 2
    Last Post: 11-01-2006, 04:57 AM
  5. RFQ - small mild steel turned and drilled parts
    By mcmmach in forum Employment Opportunity
    Replies: 8
    Last Post: 07-29-2005, 03:37 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules