I have a problem wih a Colchester A110 Tornado lathe fitted with a MFB1000 barfeed.
The problem has only occurred after the machine and barfeed have been moved (about 10ft and turned 90 degrees).
When M78 is called the following alarm is displayed
"Al 112 - Division by 0 was specified".
I have read the fanuc 21iT manual and the program has not changed since the machine last worked.
Program
G21 M90
G92 S1500
T1111
M05
G0 X20. Z.3
M9999
Z0.3
M19
M78 - ALARM 112
G0 V2.3 Z.3
G4 X0
M79
W5.0
M99
My guess is the barfeed set up, so any ideas on this or any other possible solutions gratefully recieved.
Thank you in advance
Red Cap