[butchw]

I have a Bob Cambell control it is 3years old and has work very well
until know The y axis Gecko drive 203v is not working it stoped will cutting the 2 wires from the A phase and B phase terminals have been hot and they melted to gether at the terminal block. I have switch the motor and cable to another axis and they work fine. is it possible that the drive its self just failed and i just need to replace it.[email protected]

[eSilviu]

I have a Bob Cambell control it is 3years old and has work very well
until know The y axis Gecko drive 203v is not working it stoped will cutting the 2 wires from the A phase and B phase terminals have been hot and they melted to gether at the terminal block. I have switch the motor and cable to another axis and they work fine. is it possible that the drive its self just failed and i just need to replace it.[email protected]

in inglis pliz...