Anyone have experience with the cnc4pc C32 - Dual Port Multifunction CNC Board? Planning on a retrofit for a Bridgeport Boss 4 running existing steppers with either Gecko's or Larken's cobra 10's.
Anyone have experience with the cnc4pc C32 - Dual Port Multifunction CNC Board? Planning on a retrofit for a Bridgeport Boss 4 running existing steppers with either Gecko's or Larken's cobra 10's.
Hello Kosmo,
I've been looking at the same board.
I can't find a lot of info out there yet.
JAckal:cheers:
Everything is bio-degradable, if you run over it enough times with the lawnmower.