Hello everyone.
This is my first posting so I hope I'm in the right place.
The company I work for has recently purchased the above mentioned Mori Seiki and I seem to have "inherited it" :-)
It was a bank repo and the only manuals I have available at the moment are the .pdf copies. To be honest they are rather lacking in the information I require.
My first task was to write a small warm up program and after successfully trying it out I wanted to make it a "9000 series" protected program.
But, I don't seen to be able to find the parameters to allow me to do this. They are different from the usual Fanuc parameters although this control is Fanuc based
If anyone is familiar with this control and could be of assistance I would be grateful
Regards
Mick