I imported a machine from china about 6 months ago from China Nice Cut. BTW, don't deal with these guys, I speak from experience. The controls never worked correctly so out of frustration, I pulled all of the them out and am trying to get sorted with Mach 3.
Right now I have Mach 3 installed and all of the motors are hooked up. The motor drivers are Leadshine M860's, two of which I am using. The third axis is an analog ATHC to control the Z axis (plasma cutter).
I have installed Mach 3 along with a UBOB builders kit I found on the internet. When I check the installation with the Driver Test application that comes with Mach 3 it says everything is ok but I have no stepper movement.
Anything anyone can provide will be most appreciated!
Please Help!