Hi All,
Another question when running my MadCam code in Mach 3 it seems to drop to the z0 height then travel to the xy start position.
Obviously this is not ideal, especially if the piece to be cut is not perfectly level.... I don't really understand code, but is the piece of code highlighted red below telling it to go to z0 before it moves to the correct xy position?
Maybe I'm totally wrong and the code is correct but if not where do change this setting so it travels safely?
Thanks in advance,
Richard
G00 G49 G40.1 G17 G80 G50 G90 G64
G21
(FLAT_END_1.6mm)
M6 T1
M03 S16000
G01Z0.000
G00X50.362Y5.199
Z3.000
G01Z2.230 F1000
X50.100Y5.199Z-0.770 F3000
X89.010Y5.200Z-0.770