I am using a user defined woodruff key cutter that needs to cut an inner groove (like an o-ring groove). The problem is that the tool plunges and retracts through the top of the parts edge instead of the middle where it can clear. How do I change where the tool plunges and retracts to the middle of the diamond shaped toolpath below? By the way this is a 2.5 axis profiling MOP with the highlighted region set as bottom of cut geometry.
Results 1 to 2 of 2
-
12-30-2010, 07:30 PM #1
Registered
- Join Date
- Aug 2010
- Posts
- 599
Help me figure out this tool path
-
12-31-2010, 05:53 PM #2
Monkeywrench Technician
- Join Date
- Jan 2004
- Posts
- 3154
DO NOT double post your questions
www.integratedmechanical.ca
Reply With QuoteSimilar Threads
-
No tool path?
By spincaster in forum RhinocamReplies: 2Last Post: 04-07-2010, 03:37 AM -
Simple tool move - can't figure it out.
By HankMcSpank in forum MastercamReplies: 5Last Post: 02-03-2010, 07:51 PM -
can't get the tool path right
By msn_jrd in forum MastercamReplies: 3Last Post: 07-21-2008, 04:43 PM -
need tool path
By wcopley in forum BobCad-CamReplies: 7Last Post: 06-19-2008, 11:13 PM -
Tool approach Tool Path
By Kiwi in forum BobCad-CamReplies: 28Last Post: 07-05-2007, 08:35 AM
Posting Permissions
