[microbeast29]

I used to use Artcam 2008 for my 3d engravings but switched to PM10. Problem is, the Post Processor is so complicated. For Artcam I used a generic mm gcode processor. Powermill doesn't seem to offer a generic Post.

When I use one of the included Posts, my router goes all whack (I got a 3hp Chinese Model).

Anyway to get a Generic Gcode Post Processor for millimeters like the one Artcam 2008 has?

[LEARN]

I used to use Artcam 2008 for my 3d engravings but switched to PM10. Problem is, the Post Processor is so complicated. For Artcam I used a generic mm gcode processor. Powermill doesn't seem to offer a generic Post.

When I use one of the included Posts, my router goes all whack (I got a 3hp Chinese Model).

Anyway to get a Generic Gcode Post Processor for millimeters like the one Artcam 2008 has?

have you tried to contact your local Delcam dealer ? They are usually very helpful.