Hi,
I set-up and run an enc 162. I have an alarm code #2018 which reads "motor fault/ spindle variator". I contacted Tornos U.S. and was told they needed the code from the digital readout in the electrical panel in back. It read "AL- 02". I was told that my rpm's were to high for material being turned. I dropped my rpms from 3000 to 1800. it ran fine for about 8 hours. Got the same alarm code, but the electrical panel digital readout is now
"AL- 06". Can anyone tell me what the AL - 06 means? I reset the machine again and the alarm went off again without the machine even running. Any and all help is appreciated.

Thanks