[69owb]

I need Help
I have Micron position Transducer on my mill and I'm trying to figure out which wires go were? It has one black & one red wire going to a harowe dc tack and 6 other wires going to a Harowe resolver 11BRW-300-F. I haven't been able to find any wiring schmatics on it yet. Is there a way I can determine which wire is which. Thanks


terminal block# = wire color

10 = Red go's to DC TACK
9 = Black go's to DC TACK
8 =
7 =
6 = Blue go's to RESOLVER
5 = Black go's to RESOLVER
4 = Yellow go's to RESOLVER
3 = Pink go's to RESOLVER
2 = Red/white stripe go's to RESOLVER
1 = yellow go's to RESOLVER

[HillBilly]

There should be three seperate windings in the resolver. The one that ohms out to the wire with the white stripe should be the rotor ( This will be the one that has a sine wave applied to it, usually 2.5khz.). The remainding two windings will be the A and B coils wound on the stator.

Darek