[mfirdaus0708]

Sincerely,
I have a machine JWX-10 & MDX-40, these machines have the same problem that when mounted rotary all the coordinates X, Y, Z & A such as collide and if calibrating the origin Y, Z axis always hit the rotary. If I move the X axis, Y & Z axis always participated, about what's the problem?

I've replace rotary board, mainboard & rotary motor, but the result is the same

thx

[mahanta]

Hi,
I have jwx10 too and during 2 days when i want calibrate my machine the 1/8" pin dont countact with calibration rod and came back.After this When i push x-axis in jog mode the y-axis also move.And when i push y-axis,the x-axis also move.I dont know what happen?

[awerby]

corrupted firmware. That's the software that controls the startup and zero-sensing routines. You should contact your local Roland dealers for instructions on how to download and reload the firmware for your machines.

Andrew Werby
ComputerSculpture.com — Home Page for Discount Hardware & Software

[mfirdaus0708]

I also had to replace the mainboard TS-30 and the latest firmware update, and but same result ..

there may be colleagues who can help me for this problem, until now my machine can not be used if using a rotary, just use the table

[mahanta]

Hi,
My problem solved.I've bought new rotary axis from ProtoWizard in USA.I could calibrate my mill by this rotary axis.It must be isolated from machine table.If is not cause in jog mode X and Y collide.I isolated and solved my problem.

tkx