[allanm]

Hi All
I am a self taught OSAI controller programmer and I would like to expand my knowledge to include a FANUC controller. Can anyone point me to a good free online FANUC controller training web site? I am only assuming right now that my OSAI programs will not work on a FANUC.
If I was younger I would go back to school!

[Lasercase]

I have a lot of experience with Fanuc controllers and writing a post for Osai at this moment.
Your question isn't answered easily I'm afraid.
What kind of Fanuc, what kind of job, cutting milling etc.
In general a lot of the code can be left unchanged, Fanuc will eat it.
But wen it comes to parameter programming f.e. its quit different.
You can mail me with any question you might have and maybe I have the right guidance for you (PDF)
mailto:[email protected]

Cheers,

Case