Has anyone a schematic for the FAC-1R board of a KTK spindle drive.I have info I got a while back from George ( Machintek) which has the SOL 1 and MT 1 board drawings but not the FAC.
My fault is it is not seeing tacho voltage.When cold after a few hours it will run through one cycle ok but faults immediately at the start of the next one.
Mark.
Thread: KTK drive help
Results 1 to 1 of 1
-
01-30-2011, 05:52 PM #1
Registered
- Join Date
- Nov 2006
- Posts
- 925
KTK drive help
Reply With QuoteSimilar Threads
-
Direct Drive Vs Belt Drive for a Mill/Drill Retrofit?
By pfeist in forum Uncategorised MetalWorking MachinesReplies: 11Last Post: 02-13-2012, 09:12 AM -
Clausing Lathe Conversion, direct drive or reduced drive
By Marty_Escarcega in forum Stepper Motors / DrivesReplies: 0Last Post: 03-16-2010, 04:43 PM -
Direct Drive Plasma - Motor/drive/power supply?
By CPierce18 in forum Waterjet General TopicsReplies: 1Last Post: 02-06-2010, 12:53 AM -
Direct Drive Plasma - Motor/drive/power supply?
By CPierce18 in forum Stepper Motors / DrivesReplies: 0Last Post: 01-29-2010, 08:01 PM -
Simple, 3 Axes with Dual Drive/Motor (per axis), hardware splitter drive Interface.
By kreutz in forum Stepper Motors / DrivesReplies: 3Last Post: 07-04-2008, 12:57 AM
Posting Permissions
