Just purchased BobCadv24 and a new Haas Mini. I was looking at the list of post processors and wanted to see what someone who already has this setup recommends?
Thanks
Keith
Just purchased BobCadv24 and a new Haas Mini. I was looking at the list of post processors and wanted to see what someone who already has this setup recommends?
Thanks
Keith
Keith,
Bobcad will provide you with the correct post processor free of charge.
Give them a call Monday.
Jeff...
Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.
Ya, I knew they would...was just hoping to start playing with it a bit over the weekend.
i would imagin a generic fanuc o post should get you started.
Thanks will give that one a try too. I see two HAAS pp's on the list, one for VF machines and one for TM machines and wasnt really sure which one a mini would be classified as.
Mini used to be classified in the TM category when we first started selling them, but I'd dtart off trying the VF pp.
Thanks for the input everyone,
As it turns out, they both work fine, not sure what the initial issue was with it when I initially tried it. The Fanuc0 works as well but the table rests in a different place when the program finishes running.
On a side note, TM and VF both worked the ATC with no problems