thanks for the insight...I havent even looked at the thing yet other than give it a spin, feels like gears clashing...but pretty certain theres no gearbox on a motorized spindle...
quick question- are the bearings straight bore angular contact or taper bore cylindricals? just wondering if its gonna be expensive or real expensive
Tim
Results 1 to 4 of 4
Hybrid View
-
02-09-2011, 06:23 PM #1
Member
- Join Date
- Feb 2011
- Posts
- 640
-
02-09-2011, 07:09 PM #2
Gold Member
- Join Date
- Feb 2009
- Posts
- 6028
It going to be expensive, you CAN NOT CHANGE BEARINGS YOURSELF. This has an armature on the spindle shaft with hydraulic nuts. Only re-builders with the correct equipment can do these. If you try to do it yourself, you will be buying a brand new spindle from Mori. Figure 5K minimum for rebuild. Then you will need the upper bearing, about 600.00 additional. The upper bearing sits in a floating housing, with ball bearings to allow it to float. This is not a simple job on a SV. The newer machines are pretty easy.
Reply With QuoteSimilar Threads
-
Arrow 500 need drawing for drawbar assembly
By scudzuki in forum Cincinnati CNCReplies: 4Last Post: 08-22-2016, 08:51 PM -
Spindle Assembly Drawing for Mori VMC SV500/40
By shivisood_24 in forum Mori Seiki MillsReplies: 1Last Post: 12-18-2010, 01:56 AM -
Boss R2E3 - need drawing of head assembly
By Scott Kelley in forum Bridgeport / Hardinge MillsReplies: 0Last Post: 09-08-2008, 09:31 PM -
Creating cavity from assembly parts?
By Rich05 in forum SolidworksReplies: 2Last Post: 07-24-2008, 01:01 AM -
Trimming parts in assembly
By Capgama in forum SolidworksReplies: 1Last Post: 09-19-2006, 03:49 PM
Posting Permissions
