Hi my names Jordan
I was looking to grow my small engineering firm by going down the turned parts road. I have recently purchased a Hitachi Seiki 3ne 300 lathe with fanuc t6 controls. I was told there where a few niggles with this lathe hence it being free from a friend who was going into liquidation. Now I have had it wired in and when I power it up it says not ready (i know this normal). The next thing on the screen when pressing the standby button is
U 0.000
W 0.000
00012 N0012
Also I know this is normal.
But next when i move the turret on the x axis on the joy stick all is fine but as soon as i move the y axis theirs a clonk and alarm code 401 servo.
Any ideas whats doing this i have
Thanks Jordan