Help Please,
Does anyone have a spindle bearing replacement procedure for this or ANY Mazak belt driven milling spindle. 1999 Integrex 200 SY - turret is a typeI 6000rpm unit. I have read elsewhere that these bearings are "field serviceable"
The machine has 2 ring gears which drive the spindle. The backlash between them is huge and causing the noise. The machine hasn't run much in this condition because there is no tooth damage on the gears.
It is likely due to looseness in the rear spindle bearing. I would like to send it out but am very short of cash and need to use the machine ASAP for at least 6-9 months before I could consider big money rebuild.
What is the factory backlash for these gears?
What are the reassembly torque specs?
What is the general dissassembly/reassembly procedure?
Any help would be greatly appreciated.
Thanks
Rob
[email protected]