I recently purchased a CamTech Routermaster 52 that is not working properly.
When I was initially looking for a CNC Router I was considering building my own - it didn't look very complicated or expensive. My impression of the machine I bought is that it is very solid, but the controls are outdated.
Currently, one of the step motors is not working properly on the x-axis and there is also a problem on the z-axis. The y-axis works fine
Does anyone have experience upgrading an older machine (1995) without having to spend a lot of money?
If I was to purchase new drives, powersupply, breakout board, and software could I expect to have a working machine. I know that is a rather general question, but if anyone has some input it would be greatly appreciated :wee:
Thank you
The stepper motors are
VEXTA PH296L-01
2 phase
1.7 Volt
4.7 Amp
The controller is a CamTech
RMMXZ51ABCTCMJEO
serial# 1389-9508