[Techbuilder]

Hi everyone I was hoping maybe you might be able to help me out with a question I have.
Well I wanted to build my own servo controlled Rotary indexer and a Trunnion Table and I was curious if it is hard to interface to a yasnac controller with a 4th axis?

Any help would be greatly appreciated

[Sixtysix66]

Hi Techbuilder,

I have a Matsuura MC 500 V2 with a Yasnac Mx1 (or MX2) controller. The machine also has a retrofitted Nikken 4th Axis with its own Fanuc Mate controller. The machine is about 25 years old, but I have only had it a few months. I have not been able to use it so far because it has a fault, probably a minor one. I have started serious fault finding on it since yesterday. If you need any information please let me know.

Regards

Sixtysix

[Delw]

mo its not hard just make sure you get the same drive(yasnac and the motor yasnac

My acroloc ran a mx1 control with a 4th and had no problems with full 4th axis( wasnt just indexing)

you can pretty much use any drive and motor you just need to have the right signal/
I know a guy with alot of yasnac parts (drives/motors))and even 4th axis's, pm me if you want his name