[Maglin]

Thank you alot MrCodewiz. I was able to just learn how to use use my CAM program with your dxf's. I think I might even make a set and sell them to a forum member for good practice. Man feeds and speeds make a huge difference in time. Went from 8 min to 2.6 hours and now down to 40 minutes on the X Bracket. Now I have the speeds correct I'm pretty sure. Thank you again. This was a great learning experience for me.

[SuperFlyLoser]

I have a quick question. I did a rendering of the X-Axis mount and I can not figure out the dimension for the bolt holes that mount to the table. In the attached picture its the 2 locations circled in Red. Thanks for any info you can give on the placement.

If you don't care I can post the 3dm or DXF files of the 3d model I made from your prints.

[IMG][/IMG]

[mrcodewiz]

It's metric, but does this help? the 17mm is distance between the center of the ballscrew pocket to the center of the mounting hole.

[SuperFlyLoser]

Yes, That helps tremendously! Thanks a million!

Update.

Here is the finished product. Thanks!

[sledhead306]

ok wgatfc