I have just bought a small three axis router/engraver and am having some difficulties pulling .dxf files into various programs that are supposed to create G-code. When the file is pulled in the programs create no code and some say nothing is found to create code from!
Here's my scenario:
- I open ACad 205 and pull in a jpeg.
- I then create a second layer and make a tracing of an area of the jpeg using the spline tool.
- I save as a .dxf file
Do I need to somehow make this second layer a standalone single layer drawing? If so how is that accomplished as I can't delete the layer 0 even after deleting the jpeg from it.