Will Mach3 allow you to slave more than 1 axis. I am building a large gantry and want to drive the gantry forward and backwards, say Y axis and A axis.
I also want to be able to drive both ends of the Zaxis up and down as I am spaning 8 feet. Can this be done?
Thread: Slaving more than 1 axis
Results 1 to 2 of 2
-
03-22-2011, 12:39 AM #1
Registered
- Join Date
- Feb 2011
- Posts
- 0
Slaving more than 1 axis
-
03-22-2011, 01:52 AM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
Haven't tried it, but it lets you set up a slave for the the X, Y, and Z. So I guess you can.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
y axis slaving off
By electric2u in forum Mach MillReplies: 2Last Post: 04-29-2010, 02:17 AM -
slaving y axis motor for 4x8 cnc
By eloid in forum DIY CNC Router Table MachinesReplies: 30Last Post: 11-25-2009, 05:27 PM -
X/A axis slaving issues
By jhowelb in forum Mach MillReplies: 4Last Post: 10-22-2009, 05:41 AM -
Slaving axis & other issues
By Georgie in forum Mach MillReplies: 5Last Post: 04-17-2009, 09:19 AM -
Slaving 2 axis together Mach3
By retromulticam in forum Mach Software (ArtSoft software)Replies: 1Last Post: 04-30-2008, 01:42 AM
Posting Permissions
