586,075 active members*
3,841 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > CNC (Mill / Lathe) Control Software (NC) > Virtual Village TA8435 3-Axis Driver Board Pin-Out Info Request

Thread: Virtual Village TA8435 3-Axis Driver Board Pin-Out Info Request

Results 1 to 2 of 2
  1. 03-27-2011, 04:08 PM #1
    2000ZxT
    2000ZxT is offline Registered
    Join Date
    Aug 2008
    Posts
    2

    Virtual Village TA8435 3-Axis Driver Board Pin-Out Info Request

    I have not been able to locate any information after hours of searching everything seemingly possible on the internet. I actually have the older 4th axis built in style-board but I assume the pinouts for the main axis' should be the same.

    This is the Chinese board sold by Virtual Village. If anyone has a link to a manual or at least the pinout information for the "Tonsen TS-3+1X" driver board I would greatly appreciate it. Also this thread will come up immediately for anyone searching so it should make things easier for everyone.

    This is the board in question:
    Reply With Quote Reply With Quote
  2. 03-28-2011, 02:47 PM #2
    2000ZxT
    2000ZxT is offline Registered
    Join Date
    Aug 2008
    Posts
    2
    Answered my own question. 007807-097 | downloads.virtualvillage.com

    Finally got it working, the directions are pretty awful but it is proving to be a decent board.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 5 axis TA8435 stepper driver board-confused
    By tiffyted in forum Stepper Motors / Drives
    Replies: 16
    Last Post: 09-18-2010, 12:36 AM
  2. 3 axis driver board
    By Dave Rothermel in forum Servo Motors / Drives
    Replies: 4
    Last Post: 03-16-2009, 04:50 AM
  3. Check this open source board! (TA8435 based, schematic and pcb...but)
    By patriciooholegu in forum Open Source Controller Boards
    Replies: 2
    Last Post: 12-14-2008, 05:36 PM
  4. single axis driver and a b.o.b.,or multi-axis driver board
    By .xXACEXx. in forum Stepper Motors / Drives
    Replies: 3
    Last Post: 07-03-2007, 05:13 AM
  5. fet 3 15 amp 3 axis driver board (stepperworld)
    By mike10 in forum Stepper Motors / Drives
    Replies: 17
    Last Post: 04-30-2005, 04:30 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules