I have had no problem importing dxf and posting Sheetcam (tap) then running it in Mach3. Now I been notes it's been taking longer to load Gcode in Mach3 and not cutting as clean as before. So I zoomed in on the drawing in Mach3 and the drawing is stacked up in the Z axes in a spiral. I don't know I did different.
Hope someone can help me Thanks Jay
Results 1 to 2 of 2
-
04-04-2011, 01:22 AM #1
Registered
- Join Date
- Jan 2010
- Posts
- 9
I'm not sure where the problem is coming from autocad or sheetcam
-
04-04-2011, 03:39 PM #2
Registered
- Join Date
- Jan 2010
- Posts
- 9
But now I remember It started when I changed post processor to mp3000-dthc-high ref. Because I finished my Z axes for the THC but it had a issues so I turned it off to finish my cut outs. I changed post processor back to Mach3 plasma a simple on and off processor. The cuts are smooth again but now the torch will not fire off at the beginning of line segment. When rains it pours. Thanks Jay
Reply With QuoteSimilar Threads
-
problem with z in sheetcam
By nic6911 in forum SheetCamReplies: 1Last Post: 10-02-2010, 01:45 PM -
Autocad to Mach3 problem with arcs
By LTP in forum Mach LatheReplies: 3Last Post: 07-25-2010, 03:08 PM -
Autocad R14 Problem
By freak_brain in forum AutodeskReplies: 8Last Post: 08-27-2006, 09:54 PM -
sheetcam -> Mach2 problem/question
By anthony in forum SheetCamReplies: 13Last Post: 08-21-2005, 09:56 PM
Posting Permissions
