586,058 active members*
3,534 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Viper Servo drives > Parameter Bank Select Viper 95

Thread: Parameter Bank Select Viper 95

Results 1 to 3 of 3
  1. 04-19-2011, 10:16 AM #1
    cnc_oz
    cnc_oz is offline Registered
    Join Date
    May 2006
    Posts
    18

    Parameter Bank Select Viper 95

    Hi Larry,
    Manual V2.0.1 shows the Parameter Bank Select jumpers (Page 32).
    What I cannot find is which end of the plug I should count from.
    ie Is the reverse motor jumper nearest the board edge or opposite edge.
    I dont see any printed info on the PCB itself.

    I dont want to stick jumpers on to find out I have counted from the wrong end.

    Thanks
    John
    Reply With Quote Reply With Quote
  2. 04-23-2011, 05:01 PM #2
    Larken
    Larken is offline Member
    Join Date
    Feb 2007
    Posts
    966
    The bottom of the board is there the motor connectors are. (The encoder and motor output)

    The top is the 5pin programming connector. The reverse jumper is at the top.

    Larry
    Reply With Quote Reply With Quote
  3. 04-24-2011, 02:08 AM #3
    cnc_oz
    cnc_oz is offline Registered
    Join Date
    May 2006
    Posts
    18
    Thanks,
    I will mark my manual appropriately.

    Regards
    John
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. PIC18F bank access
    By The Blight in forum PIC Programing / Design
    Replies: 2
    Last Post: 04-21-2024, 01:39 PM
  2. Viper V-950/OS crashed,lost all parameter
    By jesse297 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 10
    Last Post: 11-18-2022, 07:45 PM
  3. Capacitor Bank Help
    By Shanghyd in forum Phase Converters
    Replies: 3
    Last Post: 08-18-2009, 05:52 AM
  4. multi drill bank/head
    By pinkjas in forum DIY CNC Router Table Machines
    Replies: 1
    Last Post: 04-07-2009, 08:04 AM
  5. scmi drill bank
    By wcmboss in forum Commercial CNC Wood Routers
    Replies: 5
    Last Post: 03-23-2007, 03:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules