Hi, I'm very new to this and was wondering if any of you can help me. I have an application where I need to use a linear actuator that will just have this one movement(in and out), but I need to change the speed, and distance, I guess called different motion profiles? The actuator will travel about 8" in 30 to 80 seconds(in this range) with different start, middle, and end speeds. What I have is a Slo-Syn motor on this actuator, but I don't have anything else. The motor is a 4 wire I guess Bi polar Model# KMLO93FO8, it says 4.0 amps, 200 steps. What driver, and or controller should I get(and where), or should I start over with a different motor on this actuator? I need the strength close to the size of this motor, I think the actuator with this motor is rated close to 400 Lbs. of pushing force. I know this is a lot, but any help would be great, thanks, Enzo
See attached pic.....