hello
I bay gcc laser New Mercury. If I send graphic on laser, sometimes file will do "stop-freeze" on PC printer front and I must extract USB connector and push in back and print again.
you do not know ....where is problem??
Thanks
hello
I bay gcc laser New Mercury. If I send graphic on laser, sometimes file will do "stop-freeze" on PC printer front and I must extract USB connector and push in back and print again.
you do not know ....where is problem??
Thanks
First of all do proper grounding. Unscrew any screw from laser body and with sandpaper remove paint absolutely. Buy copper wire and connect this screw to grounding contour.
Hello
Thanks for answer. I try your help but problem is always :-(
Change USB cable, delete and install printer once more. What is your OS?
OS is WIN XP 32bit. Cable and delete and install printer once more.... I was trying.
1) How often this happened
2) When you got this laser? If within last two months - check PM in 30 min
3) May be you can reload firmware?
This problem is unusual for Mercury